Baymak Jet 112-50LT Horizontal Tank Booster Pump, 6 Floors, 6 Apartments

Baymak Jet 112-50LT Important Notes

• Baymak booster pump initial start-up must be carried out by an authorized Baymak service center. Otherwise, the warranty will be void.
• Transport the Baymak Jet 112-50LT only in its original packaging, observing the warnings on the box.
• For installation of the Baymak Jet 112-50LT, it is recommended to draw suction at least 30 cm above the tank floor to prevent foreign particles in the water (sand, etc.) from damaging the unit.
• The Baymak booster pump must not be connected to draw directly from the city mains; it must draw from a storage tank.
• Do not interfere with the expansion vessel valve; it is charged with compressed air when there is no water in the pump.
• The pressure switch has been factory-set; do not make any adjustments.
• It is recommended to install the Baymak booster pump in a well-ventilated location where the temperature does not exceed 40 °C.
• Install the suction and discharge pipes with clamps so that the load is transferred to the wall.
• If Baymak Jet 112-50LT fails to move after being stopped, loosen the shaft at the rear of the motor.
• If the water inside the unit is to be completely drained, this must be done in an environment below 0 °C. If the unit will not be used for an extended period, draining is recommended to prevent internal corrosion.
• Follow the information on the Baymak Jet 112-50LT label and install a circuit breaker proportional to the current.
• Under no circumstances allow anyone other than authorized service personnel to work on the unit.
• For the installation piping: if metal pipe is used, the inlet/outlet diameters must be the same; if plastic pipe is used, the next size up should be selected.
• The suction line should be as short as possible (maximum 6 m) and made with the fewest possible fittings.
• Never run the Baymak Jet 112-50LT dry. Otherwise, the mechanical seal, impeller, and electric motor will burn out and the warranty will be voided.
• We recommend using the Baymak Jet 112-50LT with a control panel for protection against electrical faults.