Digital Pressure Switch, 0.1-10 Bar, Precise Adjustment

Product description

Digital Pressure Switch Specifications

The digital pressure switch features dry-run protection, which protects the motor against running without water. This function can be enabled or disabled. The activation delay is 2 min.

The digital display on the unit shows the operating pressure of the booster pump. Because you can read the current pressure digitally, there is no need for an additional pressure gauge on your booster pump.

Settings are made using the 4 buttons visible on the image of the digital pressure switch.

• The H button is used to set the upper cut-off pressure of the booster pump. Simply use the up/down buttons to set the pressure at which you want the booster pump to switch off.
• The L button is used to set the lower cut-in pressure of the booster pump. Simply use the up/down buttons to set the pressure at which you want the booster pump to switch on.
• You can set a time delay to prevent the pump from cycling on and off frequently. Holding buttons 1 and 2 simultaneously for 3 seconds displays the value n03. When the pump reaches the set pressure, it waits 3 seconds before acting. You can increase or decrease this time delay as needed using buttons 2 and 3.
• If no action is taken on the settings screen for 3 seconds, the current settings are saved and the screen exits.
• Turning dry-run protection on or off. Dry-run protection comes enabled by default from the factory. If the motor operates at a pressure lower than the lower cut-in pressure set on the pressure switch, the motor is protected after 2 minutes.
• Holding buttons 2 and 4 simultaneously displays F01 or F00. In the F01 position, dry-run protection is active. Holding buttons 2 and 4 again switches to F00, disabling dry-run protection.
• When the digital pressure switch activates motor protection, the error code E-F appears on the display. Press any button to reset it.

Digital Booster Pump Pressure Switch Technical Values

• The electronic pressure switch can be used with motors up to 1.5 kW.
• Adjustable between 0.1 bar and 10 bar.
• Precision adjustment at 0.1 bar increments.
• The booster pump pressure switch can be used with 220 V single-phase motors.
• Usable up to 10 amperes.
• For use with 380 V or other voltages, a contactor must be used.
• The water pressure switch can be used at temperatures up to 80 °C.
• IP66 protection rating.
• More than 20 million switching cycles.

Similar products

• Forza Liquid Level Float Switch, 1.6 m, Rubber Cable, Electric – $9.64
• Nano Water Filter, 1 Inch – $171.69
• Element Flexible Hose with Elbow, 100 cm, 10 bar, 1″ – $16.91
• Mirox 1-6 Single-Phase No-Drain Pressure Switch, 1/4″ Connection – $17.17
• Italtecnica PM 5-3W Five-Way Pressure Switch with Pressure Gauge, 1–5 Bar, 220V – $32.22
• Pakkens Thermometer, -30+60°C, Ø63 mm, 5 cm Immersion Length, Rear Connection, G 1/2" – $7.09
• Brass Reducer, 1/2" – 3/8" – $1.47
• Caleffi 5080 Automatic Air Vent for Radiators, 1/2" – $4.36
• Welko Automatic Boiler Fill Valve, 1/2'', DN15 – $41.19
• Mit MB-01 Brazed Plate Heat Exchanger, 12 Plates, Connection 3/4"–1/2", 180 L/h – $66.31